I didn't know you could take a duplex apart like this:)

[Elitopus1]

I just didn't know you could take one of these apart like that. I figured you would destroy the drivers getting them apart. Maybe its different with the T50. I know on my 604G and 616 duplexes, the HF driver almost looks like it molded on. Its probably just the paint. I see no way of taking them apart. Probably if the cone wasn't there the screws would be accessible.

How are the individual 515 and 802 constructed versus a 604. Is the LF section of a 604G significantly different than a 515b? I'm just wondering if Altec took basically finished drivers and built the 604/605, or if early in the production process there were some changes made to make them fit

[Phil-G]

i probly should have read this thread a little closer before i posted. big difference between a 617 and 817

[Elitopus1]

i probly should have read this thread a little closer before i posted. big difference between a 617 and 817

Nah its all good. I would love to hear one of the Stanley Screamer 817's with the dual 604 drivers and the large format horn on top. I just think how much money you would have in drivers in one of those nowadays

[mah]

Temptation?

Stanley Screamers (MINT) JBL speakers

[Elitopus1]

Temptation?

Stanley Screamers (MINT) JBL speakers

Its a good thing they are far away from me.

- - - Updated - - -

with one 9864 driver there would be no need for two 604 drivers and a large format driver

Ah right since those use the 299 HF driver. Maybe you could run one of those and a 604. The 802 could add a little "sparkle" to it

[bowtie427ss]

Depends when and how it was made.

A 604 won't come apart like that as in an alnico 604 the HF section has no back plate or "bottom" in it's pot so to speak, like you see in that 617 assembly.

604 HF section shares the "bottom" of the LF return pot.

It's been so long since i saw one gutted that i don't remember for sure. But, i think the HF is secured to the LF by means of 3 or 4 small screws from inside the LF pot just outside the diameter of it's magnet slug.

Sadly, i don't think a detailed cross section, or sectional view of a 604 exists. If somebody has one(or internal pics), please post.

[Elitopus1]

Thanks bowtie. This is the first time I have seen one taken apart. I always figured you couldn't do that. Is the 515 section of the 604 the same as a regular 515? Like are all the magnet slugs made with the 1" hole in the middle?
There is a 515b listed on ebay that has a hole in the magnet cover. It looks like it was either a 604 previosly or all 515's have that hole that is covered somehow. This one

[Phil-G]

Nah its all good. I would love to hear one of the Stanley Screamer 817's with the dual 604 drivers and the large format horn on top. I just think how much money you would have in drivers in one of those nowadays

with one 9864 driver there would be no need for two 604 drivers and a large format driver